Image Settings; Mask Settings - Nuvico Xcel D-PL800 User Manual

Table of Contents

Live View Introduction

5.4.2 Image Settings

Click StartSettingsCameraImageImage Settings to go to the following interface.

Select the camera and then set the brightness, contrast, saturation and hue of the camera. Click

"Advanced" button or

"Image Adjust" interface and then set the relevant setting items. Please refer to 5.4.5 Image

Adjustment for detailed introductions of these items.

You can click "Default" button to restore the image settings to the default factory settings.

Some areas of the image can be masked for privacy. Up to four mask areas can be set for each

camera. Click StartSettingsCameraImageMask Settings to go to the interface as

shown below. Select the camera and enable the mask. Click "Draw" button and then drag the

in the camera list on the right side of the interface to pop up

DVR User Manual

Table of Contents