Port Configuration - Nuvico Xcel D-PL800 User Manual

Device Management
Multiple Address Setting:
If "Multiple Address Setting" is selected, the IP addresses of the two Ethernet ports should be
set respectively. Refer to the picture as shown below.
Check "Obtain an IPv4 address automatically", "Obtain an IPv6 address automatically" and
"Obtain DNS automatically" to get the network addresses automatically, or manually enter the
network addresses; select one Ethernet port as the default route and then click "Apply" to save
the settings.

11.1.2 Port Configuration

Click StartSettingsNetworkPort to go to the interface as shown below. Enter the HTTP
port, HTTPS Port, server port, RTSP and POS port of the DVR, enable "Anonymous" as
94
DVR User Manual