View Network Status; Basic Configuration; Common Configuration - Nuvico Xcel D-PL800 User Manual

Table of Contents

Device Management

Click StartSettingsNetworkPlatform Access to go to the interface.

Platform Access

① Set "Access Type" as "Platform Software" and select "Enable" as shown below.

② Check the IP address and port of the transfer media server in the ECMS/NVMS. The

default server port for auto report is 2009. If it is modified, please go to the transfer media

interface to check.

③ Enable the auto report in the ECMS when adding a new device. Then self-define device

ID and fill out the remaining information of the device in the ECMS/NVMS.

④ Enter the above-mentioned server address, port and report ID in the server interface. Then

click the "Apply" button to save the settings. Now the ECMS/NVMS system will

automatically connect this device.

11.1.10 View Network Status

Click StartSettingsNetworkNetwork Status to view the network status or click

the tool bar at the bottom of the live view interface to view network status conveniently.

Click StartSettingsSystemBasicGeneral Settings to go to the following interface.

102

DVR User Manual

Table of Contents