Motion Alarm Handling Configuration; Intelligence Alarm; Object Detection - Nuvico Xcel D-PL800 User Manual

Table of Contents

Alarm Management

the duration time is set to 10 seconds, once the system detects a motion, it will go to alarm and

would not detect any other motion (specific to camera) in 10 seconds. If there is another motion

detected during this period, it will be considered as a continuous movement; otherwise it will

be considered as a single motion.

③ Drag the camera image to set the motion area. You can set more than one motion area.

Click "All" to set the whole camera image as the motion area. Click "Reverse" to swap the

motion area and the non-motion area. Click "Clear" to clear all the motion areas.

④ Click "Apply" to save the settings. Click "Processing Mode" to go to the alarm handling

configuration interface of the motion alarm.

9.2.2 Motion Alarm Handling Configuration

① Click StartSettingsAlarmMotion Alarm to go to the following interface.

② Enable or disable "Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer",

"Pop-up Video" and "E-mail". The alarm handling setting of motion alarm is similar to that of

the sensor alarm (see 9.1 Sensor Alarm for details).

③ Click "Apply" to save the settings. You can click "Motion Settings" to go to the motion

configuration interface.

Object Detection Configuration:

① Click StartSettingsCameraIntelligent AnalyticsObject Detection to go to the

following interface.

② Select the camera, enable the object detection and set the duration and detect type. There

DVR User Manual

Table of Contents