Table of Contents
Advertisement
Installing the Projector
c
Press the [Focus/Distortion] button on the control panel again.
Press repeatedly until the distortion adjustment screen is displayed.
d
Press the [ ][ ] button to adjust the focus of the surrounding
area.
If the center is out of focus after adjusting the surrounding image,
repeat steps 1 to 2.
a
You can also adjust distortion in images using the remote control.
After adjusting the focus at the center of the image using the [Focus]
button [+] [-], use the [Distortion] button [+] [-] to adjust the
surrounding image.
Registering and Loading Lens Adjustment Values
You can register a lens position whose lens shift, zoom, focus, and
distortion was adjusted in memory, and load it when necessary. You can
register up to 10 values.
a
• If you did not calibrate your lens, a message is displayed when you
save a memory. Select Yes to calibrate the lens.
• The lens position when a memory is loaded may not completely
match the lens position when the memory was saved.
• If there is a large discrepancy between the lens position when a
memory is loaded and the lens position when the memory was
saved, calibrate the lens.
s Extended - Operation - Lens Calibration
a
Press the [Memory] button while projecting.
a
You can also operate from the Configuration menu.
s Settings - Memory
p.125
p.123
35
Advertisement
Table of Contents
