Hatteland JH 19T01 MIL User Manual page 21

Naval multi display
Table of Contents

Advertisement

General Installation Recommendations
Maximum Cable Length
The RGB/DVI cable should generally be kept as short as possible to provide a high quality output
on the display. The maximum cable length will depend on the signal resolution and frequency, but
also on the quality of the signal output from the computer. Recommended is 60Hz vertical
frequency.
Cables up to 10 meters generally provides good picture quality even with a 1600x1200 (UXGA)
60Hz signal. In most cases (especially with lower resolutions) even longer cables will provide a
satisfactory result. This should however be tested in advance before making the decision on how
far the unit can be placed from the signal source.
Standard Bracket
When mounting the bracket on the MIL products, the length of the bolts should not exceed 12mm.
Using any longer bolts will do serious damage to components inside the product, and will void
warranty!
Mount bolts on both sides of the bracket/display.
You make any adjustments before securing the bolts.
Adjust the tilting angle and secure the bolts.
Rotary Bracket
This can only be mounted if your product is equipped with a Standard Bracket.
Use the provided bolts to secure it. You may choose your own bolts to secure it to a table or
desktop, recommended size are: M10 and minimum 30mm in length.
Installation
21
INB100005-3 (Rev 9)
IND100078-6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jh 20t03 milJh 20t04 milJh 23t02 mil

Table of Contents