Serial Communication (SCOM) Interface
Comm settings #1 (before Jan 2005 - pre-HW01 models)
The communication options are set by switches, placed at the backside of the display. For most
displays, these switches are labelled like seen on the illustration below. For adjustments, a thin
object is required for reaching the switches. Some displays do not have this label or the dedicated
holes. To change the settings, these switches can either be reached through the ventilation holes or
the back cover must be demounted.
NOTE: The placement of the switches may vary from product to product!
By factory default the comport is set to RS232 mode, unless customer specified.
[ Note: JHSCOM placement for products released and introduced BEFORE Jan 2005]
Communication Interface
IND100084-1
Communication mode
Straight/Reverse
Rx/Tx for RS422, COM1
6
INB100005-3 (Rev 9)
Duplex
Address