Osd Menu Functions - Hatteland JH 19T01 MIL User Manual

OSD Menu Functions

BRIGHTNESS AND CONTRAST: (No function in DVI mode)
2
Selecting this function will enable the user to adjust brightness and contrast
4
for the display.
(No Function in DVI) BRIGHTNESS:
(No Function in DVI) CONTRAST:
COLOR TEMPERATURE
2
Selecting this function will enable the user to modify the warmness of the picture.
4
Higher temperature = "cooler" picture. Lower temperature = "warmer" picture.
User can select between 9500K, 8000K, 6500K, and 5000K color temperature measured in
Kelvin degrees. Press "+" to access the sub-menu, where the RGB values can be adjusted.
Use "+" and "-" buttons to adjust these values, and "MENU" to exit. (Saving is done automatically)
FREQUENCY AND PHASE: (Some functions not available in DVI mode)
1
2
Selecting this function will enable the user to modify the image horizontal size and
fine tune the image quality.
(No Function in DVI) FREQUENCY:
(No Function in DVI) PHASE:
(No Function in DVI) SHARPNESS:
PICTURE TYPE
VIDEO ADJUSTMENT:
Selecting this function will enable the user to modify the color saturation of the
4
3
picture, tint and sharpness.
COLOR:
TINT:
SHARPNESS:
PICTURE TYPE
VIDEO TYPE
VIDEO SYSTEM:
Selecting this function will enable the user to select video system and input signals.
3 4
AUTO
NTSC / NTSC 4.43
PAL / PAL M
SECAM
User Controls
IND100064-17
Increase/decrease brightness level, total: 100 steps
Increase/decrease contrast level, total: 100 steps
:
Increase/decrease the image horizontal size.
Fine tune the data sampling position (adjust image quality.)
Increase/decrease video image sharpness level.
: Motion / Still (Adjustment for best image quality)
If graphics on screen move a lot, select "Motion"
If graphics on screen are mostly still, select "Still"
Increase/decrease video color level.
Increase/decrease tint level.
Increase/decrease video image sharpness level.
: Motion / Still / Normal (Adjustment for best image quality)
If graphics on screen move a lot, select "Motion"
If graphics on screen are mostly still, select "Still"
General motion - non flicker mode, select "Normal"
: Change to best match the source signal. (DVD / VCR)
: Automatic detection of NTSC or PAL system. (Not applicable in SECAM)
: Manual select NTSC system.
: Manual select PAL system.
: Manual select SECAM system.
2
INB100005-3 (Rev 9)