Assembling The 3Rd Member - Taylor-Dunn SC-100-24 Operation, T Roubleshooting And Replacement Parts Manual

Maintenance, Service, and Repair

ASSEMBLING THE 3RD MEMBER

1. Temporarily install the pinion gear (hand
tighten only).
2. Install the carrier bearing race ring nuts into
the housing and cover.
3. Install the carrier bearing races into the
housing and cover.
4. Place the differential assembly into the housing.
5. Tighten the housing carrier bearing race ring nut so that the ring
gear is not in binding against the pinion gear.
6. Remove the differential assembly.
Note: Do not allow the ring nut to rotate.
7. Remove the pinion gear and then reinstall the differential
assembly.
8. Install the cover onto the housing using 4-bolts in a cross
pattern and torque to 45-50 ft-lbs.
9. Pre set the carrier bearing preload by tightening the housing
carrier bearing race ring nut until it requires 1.5 to 3.3 ft-lbs
to rotate the differential assembly.
Note: Rotate the carrier assembly whenever adjusting the ring
nuts.
Page 16
Cover
Cover
Housing
Housing