Maintenance, Service, and Repair
INSPECT THE SERVICE BRAKE
Disc Brake Pads
NOTE: The brake pad must be removed to accurately measure the lining thickness. Refer to Replace
the Front or Rear Brake Pads section for information on removing the brake pads.
Measure the brake pad lining at the thinnest point on the pad. If the brake pad lining is 1/16-inch or less
then the brake pad must be replaced.
It is recommended to replace the left and right side brake pads as a set.
Page 2
Current Taylor-Dunn
possibility that the original brakes were replaced with aftermarket
parts containing asbestos. Since this possibility exists, all brake parts
should be handled as if they contain asbestos. Refer to appendix C
for recommended handling precautions.
brakes are asbestos free. However, there is the
®