Signet Charger Operation, Model Hbs Series - Taylor-Dunn SC-100-24 Operation, T Roubleshooting And Replacement Parts Manual

SAFETY RULES AND OPERATING INSTRUCTIONS
WARNING
Explosive mixtures of Hydrogen gas are present
within battery cells at all times. Do not work
with or charge a battery in an area where open
flames (including gas furnace or water heater
pilots), sparks, cigarettes, or any other sources
of combustion are present. Always provide
ample ventilation in rooms where batteries are
being charged. Failure to do so may result in
severe bodily injury and/or property damage.
WARNING
Battery electrolyte is poisonous and dangerous.
It contains sulfuric acid. Avoid contact with
skin eyes or clothing. Wear rubber gloves and
safety glasses while servicing batteries. DO NOT
INGEST! This may result in severe bodily injury.
WARNING
The charger must be connected to a properly
grounded AC receptacle. Improper connection
will increase the risk of electric shock and can
cause severe personal injury or death.
WARNING
The Signet and X-Series chargers are for lead
acid batteries only. Charging other types of
batteries may cause the battery to burst or
explode causing severe personal injury and/or
property damage.
WARNING
DO NOT disassemble the charger. There are no
user serviceable components in the charger.
Refer all repairs to a qualified technician.
Incorrect repair or reassembly of the charger
can result in an explosion, electric shock, or
fire.
WARNING
Do not attempt to operate the vehicle while
charging the battery. Operating the charger and
vehicle at the same time may lead to damage
to the charger and/or the vehicle resulting in
personal injury and/or property damage.
Safety Rules
Page 14
CAUTION
The key switch must be in the "OFF" position
when charging the batteries. Failure to turn the
key switch "OFF" may result in damage to the
vehicles electrical system.
WARNING
This charger requires a standard household
15 Amp electrical circuit. Before plugging the
charger in, confirm that your charging station
is configured correctly.
DO NOT attempt to charge two vehicles on one
standard household 15A circuit.
Failure to confirm the proper charging station
configuration or attempting to charge two
vehicles may result in fire.

Signet Charger Operation, Model HBS series

The Signet HBS series
®
chargers are fully automatic.
The charger will turn itself ON
when the AC power cord is
connected to the AC power
source and turn itself OFF
when the batteries are fully
charged. Once the charge
cycle is complete, the charger
will continue to monitor the
batteries. If the battery voltage
drops during storage, the charger will start a new cycle
to keep the batteries fully charged.
NOTE: If the charger restarts during a short time
period of storage, then it would be an
indication of faulty batteries.
Refer to the data plate on the charger for the voltage and
type power required for the charger.
There is a series of LED's on the faceplate of the charger
that serve two functions:
1. Status of charge. The STATUS LED's will display
an approximate percent of charge during the
charging cycle. Refer to the table below.
2. Error condition. The FAULT LED flashing is
an indication of a charging problem (charger
may also be beeping). Refer to the Charger
Troubleshooting
s e c t i o n f o r
information on
error codes.
Typical Signet HBS
®