Taylor-Dunn SC-100-24 Operation, T Roubleshooting And Replacement Parts Manual page 26

SAFETY RULES AND OPERATING INSTRUCTIONS
Display showing Maintenance and
Wrench icons
Safety Rules
Page 8
Maintenance Monitor:
NOTE: The Maintenance Monitor function is optional.
The Maintenance Monitor function can be
turned ON or OFF by your dealer.
Operation: The SMD notifies the operator 10-hours
(standard) before a scheduled maintenance is due.
During this warning period, the meter will continue to
alert the operator. This should allow sufficient time for the
operator to schedule the maintenance that is due, with
minimal down time. If the scheduled maintenance is not
performed before the warning period elapses, then the
vehicles maximum speed will be significantly reduced.
Warning period: The warning starts when the Maintenance
Indicator is ON and the Wrench icon is flashing. The
Wrench icon will continue to flash until the warning time
has expired.
Maintenance Due: Once the warning has expired and the
maintenance is due, the Wrench icon will stop flashing
and remain ON. Additionally, the vehicles maximum
speed will be significantly reduced until the maintenance
is performed and the display is reset. The display should
only be reset by an authorized technician. Refer to the
section for information regarding tools
Illustrated parts
required to reset the Smart View Display.
Speed controller status: The display will indicate a
fault code whenever the control system logic detects a
problem with the control system. A fault code is being
displayed whenever the Fault Code Indicator (the letter
'F') is visible at the left of the numeric display. Refer to the
fault code table in this section for a summery description
of the fault codes.