Center The Steering Wheel - Taylor-Dunn SC-100-24 Operation, T Roubleshooting And Replacement Parts Manual

Center the Steering Wheel

6. Position the front fork in the straight ahead position and tie it off so that it cannot rotate.
7. Remove the steering chain access plate.
8. Remove the safety wire from the turn buckles and discard.
9. Loosen the turn buckles just enough to remove the chain
from the lower sprocket
10. Center the steering wheel as shown in the illustration and
tie it off so that it cannot rotate.
11. Position the chains so that the turnbuckles are an
equivalent distance from the steering wheel sprocket.
See illustration to the right.
12. Install the chain on the lower sprocket.
Maintenance, Service, and Repair
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Do not drive the vehicle while the steering wheel or front wheels
are tied in position. Driving the vehicle while the steering wheel or
front wheels tied in position may cause loss of control of the vehicle
resulting in severe bodily injury and/or property damage.
Steering wheel removed for clarity
Steering Components
Page 3