Foot Brake Pedal; Foot Interlock Switch; Accelerator Pedal; Park Brake - Taylor-Dunn SC-100-24 Operation, T Roubleshooting And Replacement Parts Manual

SAFETY RULES AND OPERATING INSTRUCTIONS

Foot Brake Pedal

The brake pedal is the throttle pedal located on the right side of the floorboard
positioned under the operator's right foot. The throttle pedal also functions as
the accelerator pedal. Press the rear of the throttle pedal to apply the brake.
The brake is automatically released when accelerating.

Foot Interlock Switch

A switch located under the left side of the operator platform disables the power
to the vehicle. Pressure must be maintained on the platform for the vehicle to
operate. Whenever the driver leaves the vehicle, the driver should turn the
key-switch off, place the direction control switch in the center "OFF" position,
and set the park brake.

Accelerator Pedal

The accelerator pedal is the throttle pedal located on the right side of the
floorboard positioned under the operator's right foot. The throttle pedal also
functions as the brake pedal. Press the front of the throttle pedal down to
increase speed, release the throttle pedal to slow down.

Park Brake

The parking brake is actuated with a hand lever, which is located on the left side
of the steering tower. To set the parking brake, depress the foot brake pedal
and pull the lever up until it locks. To release the park brake, depress the foot
brake pedal and push the park brake handle down.
NOTE: The treadle will be very difficult to depress when the park brake
is applied.

Reverse or Motion Alarm (Optional)

The reverse alarm is located in the electronics compartment mounted in the speed control panel enclosure. The
reverse alarm is activated when the Key switch is in the "ON" position and the direction control switch is in the reverse
position. The alarm makes a repeated audible sound.
The motion alarm is the same alarm that is used for the reverse alarm, only it operates in both the forward and
reverse directions.
Safety Rules
Page 6