Check Oil Level - Taylor-Dunn SC-100-24 Operation, T Roubleshooting And Replacement Parts Manual

Maintenance, Service, and Repair

CHECK OIL LEVEL

The oil flows freely between the main gear case (3rd member) and the primary reduction gear case. It is
only necessary to check the oil level of the 3rd member.
Park the vehicle on a level surface.
6. Place an oil drain pan underneath the 3rd member.
7. Remove the fill/level plug.
8. The oil level should be very close to the bottom of the level
plug opening.
a. If the oil level is below the bottom of the opening, add
oil as required until level with the bottom of the opening.
Refer to the Lube Chart section for information regarding
type of oil.
b. If oil comes out of the opening, allow to drain until level
with the bottom of the opening.
9. Replace the fill/level plug.
10. Reconnect the main positive and negative cables at the
batteries.
11. Remove the blocks from the wheels.
12. Release the park brake and test drive the vehicle.
Page 2
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.