Change Oil - Taylor-Dunn SC-100-24 Operation, T Roubleshooting And Replacement Parts Manual

CHANGE OIL

6. Raise the rear of the vehicle and support with jack stands.
7. Place a four quart drain pan under the drive assembly.
8. Remove the drain plugs from the differential case and gear
case.
9. Once the oil has drained, replace the drain plugs and lower
the vehicle to the ground.
10. Remove the fill/level plug and fill the differential up to the
bottom of the level plug opening. Refer to the
section for information regarding type of oil.
11. Replace the fill plug.
12. Reconnect the main positive and negative cables at the
batteries.
13. Remove the blocks from the wheels.
14. Release the park brake and test drive the vehicle.
Maintenance, Service, and Repair
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Lube Chart
Page 3