Appendixes; Appendix A: Tool List - Taylor-Dunn SC-100-24 Operation, T Roubleshooting And Replacement Parts Manual

Appendixes

APPENDIX A: TOOL LIST

The tools shown here are generic for servicing Taylor-Dunn vehicles. Not all tools will be required for servicing this
vehicle.
62-027-32: Throttle Module Analyzer
Tests the throttle module in or out of the
vehicle
62-027-61 and -62: Sevcon System Handset
Diagnostics and adjustments (-62 only)
of the Sevcon Power Pak and Micro Pak
control systems.
41-532-50: Chain Case Centering Tool
Used to center the chain case cover on all
vehicles equipped with the Power Traction
primary reduction and a pinion brake or
speed sensor. Includes instructions.
Appendixes
Appendix A
Page 2
43-201-50: Pinion Seal Installation Tool
Used to install the pinion seal on all vehicles
equipped with the Power Traction primary
reduction and a pinion brake or speed
sensor.
62-027-64 and -65: Curtis AC System
Handset
Diagnostics and adjustments (-65 only) of
the Curtis AC control system.
Molex # 11-300-02: Pin Removing Tool
Removes 0.062 diameter pins from Molex
rectangular harness connectors. Not
available from Taylor-Dunn. Purchase from
any local electronics distributor.
62-027-00: Test Light
Used for testing electrical circuits. Switchable
for 12, 24, 36, 48 volt systems.
Required to complete troubleshooting
provided in the vehicle service manuals.
96-500-43: PMT/C Meter Reset Module
Required to reset the PMT/C maintenance
meter (special order option).
Molex # 11-300-06: Pin Removing Tool
Removes 0.093 diameter pins from Molex
rectangular harness connectors. Not
available from Taylor-Dunn. Purchase from
any local electronics distributor.