Taylor-Dunn SC-100-24 Operation, T Roubleshooting And Replacement Parts Manual page 16

Maintenance, Service and Repair
MAINTENANCE GUIDELINES
Before start-
ing any re-
pairs:
•
Avoid fire hazards and have fire protection equipment present in the work area. Conduct vehicle
performance checks in an authorized area where safe clearance exists.
•
Before starting the vehicle, follow the recommended safety procedures in Section 2, "Safety Rules and
Operational Information."
•
Ventilate the work area properly.
•
Regularly inspect and maintain in a safe working condition, brakes, steering mechanisms, speed and
directional control mechanisms, warning devices, lights, governors, guards, and safety devices.
•
Inspect and maintain battery limit switches, protective devices, electrical conductors, and connections
in conformance with Taylor-Dunn's recommended procedures.
•
Keep the vehicle in clean condition to minimize fire hazards and facilitate detection of loose or defective
parts.
•
Do not use an open flame to check level or leakage of battery electrolyte.
• Do not use open pans of fuel or flammable fluids for cleaning parts.
•
Only properly trained and authorized technicians should perform maintenance or repairs to this vehicle.
Maintenance
Page 2
Periodic maintenance and service must be performed on this vehicle.
Failure to complete these scheduled maintenance and service
procedures can result in severe bodily injury and/or property damage.
It is the owner and/or operators responsibility to insure that proper
service and maintenance is performed on the vehicle, described in
this manual.
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Read and follow all of the guidelines listed below. Failure to follow
these guidelines may result in severe bodily injury and/or property
damage.