Rear Hub Or Rotor - Taylor-Dunn SC-100-24 Operation, T Roubleshooting And Replacement Parts Manual

REAR HUB OR ROTOR

NOTE: The torque specification for the axle hub bolt is 275 ft-lbs. An impact wrench will be required to
remove the bolt.
6. Raise the wheel off of the ground.
7. Remove the tire/wheel assembly, Refer to
removing the tire/wheel assembly.
8. Remove the axle hub bolt and washer and remove the hub from the axle.
9. Remove the outer brake pad. Refer to section
the brake pads.
10. Remove the rotor.
11. Install in reverse order.
a. Lightly grease the axle splines.
b. Refer to section
c. Torque the axle hub bolt to 275 ft-lbs.
Tires and Wheels
d. Refer to
12. Lower the wheel to the ground.
10. Reconnect the main positive and negative cables at the batteries.
11. Remove the blocks from behind the wheels.
12. Release the park brake and test drive the vehicle.
Maintenance, Service, and Repair
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
Brake Service
for information regarding installing the brake pads.
section for information regarding installing the tire/wheel assembly.
Tires and Wheels
section for information regarding
Brake Service
for information regarding removing
Page 5