Disassembling The 3Rd Member - Taylor-Dunn SC-100-24 Operation, T Roubleshooting And Replacement Parts Manual

DISASSEMBLING THE 3RD MEMBER

6. Raise the rear of the vehicle and support with jack stands.
7. Remove the complete drive from the vehicle.
Removing and Installing the Drive Assembly
Note: Refer to
drive from the vehicle.
8. Place a drain pan under the gear case that is capable of holding four quarts of oil and drain the oil
from the front gear case and 3rd member.
9. Place the 3rd member on an appropriate stand.
10. Remove the axle shafts and tubes as an assembly from the 3rd
member by removing the six axle tube flange bolts on each axle
tube.
11. Remove the primary reduction gear case. Refer to
and reassembly of the Primary Reduction Gear Case
for information on removing the gear case.
Maintenance, Service, and Repair
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
12. Remove the 12 side plate bolts,
then remove the side plate.
for information on removing the
Disassembly
Page 13