Taylor-Dunn SC-100-24 Operation, T Roubleshooting And Replacement Parts Manual page 79

12. Secure the brake body assembly, do not let it hang by the brake hose.
13. Pull the axle out of the housing.
14. Inspect all bearings for roughness or play, replace as needed.
15. Install in reverse order, lubricate the o-ring.
Note: Be sure not to damage the o-ring.
16. Use new bolts for the axle retaining plate.
17. If the wheel hub was removed, install the hub and rotor. Torque the hub bolt to 275 ft-lbs.
17. Fill with oil to the level of the fill plug threads. Refer to
18. Lower the vehicle.
19. Set the park brake.
20. Reconnect the main positive and negative cables at the batteries.
21. Remove the blocks from behind the wheels.
22. Release the park brake and test drive the vehicle.
Maintenance, Service, and Repair
The axle retaining plate bolts have a pre-applied thread locking
compound. They are intended for one time use only. If removed they
must be replaced. Reusing the original bolts could cause loss of brakes
resulting in severe bodily injury and/or property damage.
Rear Brakes
Refer to section
of the bolt.
Illustrated Parts
in for the part number
Changing the Differential Oil.
Page 7