Maintenance, Service, and Repair
TRANSMISSION ASSEMBLY
Remove and Install
NOTE: Refer to the illustration on the following page.
6. Disconnect the motor cables.
7. Disconnect the park brake cable from the treadle and move out of the way.
8. Disconnect the left and right brake linkages from the equalizer.
9. Remove the four transmission mounting nuts. Do not remove the bolts at this time.
10. Slowly raise the rear of the vehicle until the transmission mounting bolts can be removed.
11. Remove the mounting bolts and carefully raise the vehicle until the transmission can be rolled out
from under the vehicle. Support the frame with jack stands.
12. Install the transmission assembly in reverse order of removal.
a. Adjust the brakes. Refer to section
13. Lower the vehicle.
14. Set the park brake.
15. Reconnect the main positive and negative cables at the batteries.
16. Remove the blocks from behind the wheels.
17. Release the park brake and test drive the vehicle.
Page 8
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Brake Service
On a three wheel vehicle, when raising both rear wheels, the front
end of the vehicle must be supported to prevent tipping. The rear of
the vehicle should be raised by a means so that the left and right side
are raised equally, such as a hoist with fixed length chains attached
to the left and right side of the vehicle. Failure to properly support the
vehicle may result in the vehicle tipping over causing severe bodily
injury and/or property damage.
for information regarding adjusting the brakes.