Replace The Steering Wheel - Taylor-Dunn SC-100-24 Operation, T Roubleshooting And Replacement Parts Manual

REPLACE THE STEERING WHEEL

6. Cut the safety wire from the turn buckles and discard.
7. Remove the retaining clip and washer(s) from the steering
wheel shaft.
NOTE: The retaining clip goes completely around the shaft two
times. Locate the end of the clip and lift the end of the
clip out of the groove with a small screwdriver. The clip
can then easily be removed by rotating it around the
shaft. See the illustration to the right.
8. Loosen the turn buckles so that the steering chain can
be lifted off of the steering wheel sprocket.
9. Remove the steering wheel.
10. Install the steering wheel in reverse order.
NOTE: Lightly lubricate the steering wheel shaft.
11. Align the steering. Refer to section
steering.
12. Reconnect the main positive and negative cables at the batteries.
13. Remove the blocks from behind the wheels.
14. Release the parking brake and test drive the vehicle.
Maintenance, Service, and Repair
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Front End Alignment
Clip partially removed
for information regarding aligning the
Steering Components
Page 9