Advertisement
Step 34: Connect Monkey Bar Assembly to Fort
Part 1
Pre-drill all pilot holes using a 1/8" drill bit before installing the lag screws.
A: Using a MB Mount Strap attach (1564) MK Rail Long to (1500) Post with 1 (G10) 5/16 x 3" Hex Bolt (with lock
washer, flat washer and t-nut) in the centre hole and 2 (S6) #12 x 1" Pan Screws in the 2 end holes as shown in fig.
34.1 and 34.2.
B: Make sure the Monkey Bar Assembly is level then using a MB Mount Strap attach (1564) MK Rail Long to
(1860) MK Mount with 1 (LS2) 1/4 x 2-1/2" Lag Screw (with flat washer) in the centre hole and 2 (S6) #12 x 1" Pan
Screws in the 2 end holes as shown in fig. 34.3.
Fig. 34.1
Fig. 34.2
1860
S6
Fig. 34.3
S6
Hardware
1 x
LS2
1/4 x 2-1/2" Lag Screw (1/4" flat washer)
1 x
5/16 x 3" Hex Bolt
G10
(5/16" flat washer, 5/16" lock washer, 5/16" t-nut)
4 x
#12 x 1" Pan Screw
S6
66
5/16" Flat
Washer
5/16" Lock
Washer
S6
G10
MB Mount
Strap
1860
1/4" Flat
Washer
1500
MB Mount
Strap
5/16"
T- Nut
1564
LS2
1500
Other Parts
2 x MB Mount Strap
Advertisement
