Advertisement
Step 11: Swing Wall Assembly
Part 1
A: Attach (1872) Ground using 4 (H2) 1/4 x 2" Hex Bolts (with lock washer, flat washer and t-nut); (1501)
Floor End (in the bottom holes) and (1865) SW Roof Side using 2 (H2) 1/4 x 2" Hex Bolts (with lock washer, flat
washer and t-nut) for each board to 2 (1500) Posts. (fig. 11.1) Note: Keep all bolts loose.
B: Place (1861) SW Mount across (1501) Floor End and (1865) SW Roof Side then attach using 2 (G4) 5/16 x
4" Hex Bolts (with lock washer, flat washer and t-nut) as shown in fig. 11.1. Notice the side holes are towards the
top of the board.
Note: Pre-drill all holes using a 1/8" drill bit before installing the lag screws.
C: Make sure assembly is square and then fasten (1501) Floor End to (1500) Posts, in the top holes, using 2
(LS1) 1/4 x 1-1/2" Lag Screws (with flat washer). (fig. 11.1) Tighten all (H2) 1/4 x 2" Hex Bolts.
Fig. 11.1
1872
Wood Parts
1 x
Floor End 1 x 5 x 38-1/4"
1501
1 x
SW Roof Side 1 x 4 x 59-1/2"
1865
2 x
Post 2 x 4 x 83"
1500
1 x
SW Mount 2 x 4 x 38-1/8"
1861
1 x
Ground 1 x 5 x 75-5/8"
1872
Notice the hole
locations in (1861)
SW Mount
1865
H2
1501
H2
1500
8 x
2 x
2 x
1/4" flat
washer
5/16"
t-nut
5/16" lock
washer
LS1
1/4" flat
1/4"
washer
t-nut
H2
Hardware
1/4 x 2" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
H2
5/16 x 4" Hex Bolt (5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
G4
1/4 x 1-1/2" Lag Screw (1/4" flat washer)
LS1
32
H2
G4
1861
LS1
H2
Notice the pilot hole
locations towards
bottom of board
5/16" flat
washer
G4
1500
1/4" lock
washer
Advertisement
