Advertisement
Step 2: Rock Wall Assembly
Fig. 2.1
0606
S2
A: Lay 2 (0349) Rock Rails down, side by side with angled edges facing down. (fig. 2.1)
B: Place (0606) CE Access Board on the bottom of each (0349) Rock Rail as shown in fig. 2.1. Make sure (0606)
CE Access Board is flush to the outside and bottom edges of each (0349). Attach using 4 (S2) #8 x 1-1/2" Wood
Screws.
C: 7-3/4" down from the top of both (0349) Rock Rails place 1 (0630) CE Rock Board, making sure the sides are
flush to the outside edges of each (0349) Rock Rail. Attach using 4 (S2) #8 x 1-1/2" Wood Screws. (fig. 2.1)
D: In between the (0606) CE Access Board and (0630) CE Rock Board stagger 2 (0630) and 2 (0631) CE Rock
Boards using 4 (S2) #8 x 1-1/2" Wood Screws per board. Placing them as shown in fig. 2.1, this will prevent rocks
from forming a straight line. Make sure the boards are evenly spaced and do not exceed 2-3/8" between boards.
Fig. 2.2
S10
Rock
Wood Parts
1 x
CE Access Board 1 x 6 x 19-3/4"
0606
3 x
CE Rock Board 1 x 6 x 19-3/4"
0630
2 x
CE Rock Board 1 x 6 x 19-3/4"
0631
2 x
Rock Rail 2 x 3 x 51"
0349
0631
0630
Note: Gaps between boards 2-1/4",
not to exceed 2-3/8"
PB2
1/4" Lock
Washer
3/16" Flat
Washer
Fig. 2.3
1/4" Barrel
Nut
24 x
S2
5 x
S10
5 x
PB2
0631
0630
E: Place 1 rock on each (0630) and (0631)
CE Rock Board (fig. 2.2) and attach using 1
(PB2) 1/4 x 1-1/4" Pan Bolt (with lock washer,
flat washer and barrel nut) and 1 (S10) #8 x
1" Pan Screw per rock. The Screw must be in
the hole directly under the Pan Bolt, it will stop
the rock from spinning. (fig. 2.3)
Hardware
#8 x 1-1/2" Wood Screw
#8 x 1" Pan Screw
1/4 x 1-1/4 Pan Bolt
(1/4" lock washer, 3/16" flat washer & 1/4" barrel nut)
19
Note: The holes
in the rock boards
0349
must orient to the
top of the boards.
0630
7-3/4"
Approx
Other Parts
5 x Rocks (3 green/2 yellow)
Advertisement
