Step 15: Attach Floor Joist
A: Loosen the top bolt and remove the bottom bolt in (1861) SW Mount. Do not discard these bolts, you will re-
install them after the (0790) Floor Joist is attached. (fig. 15.1)
B: From inside of the assembly, measure 2" down from the top of each (1501) Floor End (fig. 15.2) and then
attach (0790) Floor Joist to each board in the top pilot holes with 2 (S4) #8 x 3" Wood Screws per end. (fig.15.1)
C: Re-install the bolts in (1861) SW Mount and tighten both bolts. (fig. 15.1)
Fig. 15.1
S4
0790
Wood Parts
1 x
Floor Joist 5/4 x 4 x 46-1/2"
0790
1501
Fig. 15.2
1501
0790
4 x
1861
1501
S4
Swing Wall Side
Hardware
#8 x 3" Wood Screw
S4
37
2"