Advertisement
Step 3: Swing Beam Assembly
Fig. 3.4
A: In the middle holes of (1825)
Back Beam install 2 Bolt-Thru Swing
Hangers (fig. 3.1) making sure the
swing hangers are oriented in the
direction shown in fig. 3.4 to maintain
proper swing motion.
Bolt-Thru Swing Hangers
C: Attach 1 Triangle Plate to the
ends of each (1826) Front Beam
and (1825) Back Beam using 1
(G1) 5/16 x 1-1/2" Hex Bolt (with
lock washer, flat washer and
t-nut) per triangle plate in the hole
indicated in fig. 3.2 & 3.3. Correct
hole usage is very important.
Fig. 3.3
1/4" T-Nut
G1
1/4" Flat
Washer
1/4" Lock
Washer
H7
Swing End
(With Overhang)
Wood Parts
1 x
Front Beam 2 x 6 x 83-5/8"
1826
1 x
Back Beam 2 x 6 x 83-5/8"
1825
Make sure triangle is
tight against beam
Fig. 3.1
Make sure holes are aligned.
Fig. 3.2
Important!
Swing End
(With Overhang)
H7
1825
5/16" Flat
Washer
5/16" T-Nut
Hardware
4 x
1/4 x 5-1/2" Hex Bolt
H7
(1/4" flat washer, 1/4" lock washer, 1/4" t-nut)
4 x
5/16 x 1-1/2" Hex Bolt
G1
(5/16" flat washer, 5/16" lock washer, 5/16" t-nut)
Warning: For your child's safety,
orientate the swing hangers as
shown to ensure your swing will
have proper swing motion when
installed. Failure to do so could
result in premature failure of the
swing hanger or swing chain.
B: In the end holes of (1826) Front Beam install 2
Bolt-Thru Swing Hangers (fig. 3.1) making sure the
swing hangers are oriented in the direction shown in
fig. 3.4 to maintain proper swing motion.
Bolt-Thru Swing Hangers
1826
Triangle
Plates
1826
G1
5/16" Lock
Washer
G1
D: Attach 1 (H7) 1/4 x 5-1/2" Hex
Bolt (with lock washer, flat washer
and t-nut) to the ends of each (1826)
Front Beam and (1825) Back Beam.
The bolts do not attach to anything,
but MUST be installed to the beams
H7
to prevent splitting and checking of
wood. (fig. 3.2 & 3.3)
Fort End Side
(No Overhang)
20
1825
Important!
Fort End Side
(No Overhang)
H7
G1
Other Parts
1 x Bolt-Thru Swing Hangers (pkg of 4)
1 x Triangle Plate (pkg of 4)
Advertisement
