Table of Contents
Advertisement
Setting up your system
Complete the following steps to set up your system:
1
Unpack the system.
2
Remove the I/O connector cover from the system connectors.
CAUTION:
While installing the system, ensure that it is properly aligned with the slot on the enclosure to prevent damage to
the system connectors.
3
Install the system in the enclosure.
4
Turn on the enclosure.
NOTE:
Wait for the chassis to initialize before you press the power button.
5
Press the power button on the system.
Alternatively, you can also turn on the system by using:
•
The system iDRAC. For more information, see the
•
The enclosure Chassis Management Controller (CMC), after the system iDRAC is configured on the CMC. For more information,
see the CMC User's Guide at
iDRAC configuration
The Integrated Dell Remote Access Controller (iDRAC) is designed to make system administrators more productive and improve the overall
availability of Dell systems. iDRAC alerts administrators about system issues and enables them to perform remote system management.
This reduces the need for physical access to the system.
Options to set up iDRAC IP address
To enable communication between your system and iDRAC, you must first configure the network settings based on your network
infrastructure.
NOTE:
For static IP configuration, you must request for it at the time of purchase.
This option is set to DHCP by Default. You can set up the IP address by using one of the following interfaces:
Interfaces
Document/Section
iDRAC Settings
Dell Integrated Dell Remote Access Controller User's Guide at
utility
Dell Deployment
Dell Deployment Toolkit User's Guide at
Toolkit
Dell Lifecycle
Dell Lifecycle Controller User's Guide at
Controller
Initial system setup and configuration
Log in to iDRAC
Dell.com/openmanagemanuals
Dell.com/openmanagemanuals
Dell.com/poweredgemanuals
section.
> Chassis Management Controllers
Dell.com/poweredgemanuals
> OpenManage Deployment Toolkit
Initial system setup and configuration
4
21
Advertisement
Table of Contents
