Advertisement
Reissued: 09-Sep-08
Model:
Model G-P1
Version
1.10
Meter charge mode
1.09
RPJL
1.08.1
PCL
1.07.2
Some features of a
customization added
1.06.1
Stall
1.05
Version up only
1.04.1
SC990
1.03
Color calibration sheet The color calibration sheet cannot be printed out.
T
echnical
Title
Other changes (specification change):
PM alert messages will be displayed even in Meter Click
Mode (refer to RTB RG104012).
Important: To use the above new feature, you need to
install all of the following firmware together as a set.
System v1.10 or later (P/N #G1045243J)
Printer v1.10 or later (P/N #G1045239J)
Engine v1.12:01 or later (P/N #G1045130H)
Fixed: Data containing multiple jobs that have the PJL
parameters START and END, might be cancelled
(GFPR#RA05070002).
When PCL data is printed using HDD fonts, print speed
might be reduced.
After a certain number of PCL jobs are printed using HDD
fonts, the device may stall (GFPR#RE05060001).
Some features of a customization were added as
standard:
-
The IP address is displayed on the LCD.
The IP address can be displayed on the LCD when
-
an error message occurs (Hold down the "Menu" key
for more than 5 seconds).
NOTE: To use these two features, you must set Sp5-055-
001 (Display IP Address) to "ON." You can do this from
the operation panel or from WIM.
-
Can not print Thai/Latin characters using the PS
driver.
Important:
Websys firmware v1.07 (P/N G1045235C) or later must
be used with all of the firmware together.
NIB firmware v4.14.1 or later (P/N G1045234C)
Controller v1.07.2 or later (P/N G1045239F)
Printer v1.07.2 or later (P/N G1045243F)
If a duplex job is sent using the RPCS driver and
cancelled from the operation panel or PC, the device may
stall.
(No changes).
The version name was updated for standardization with
System v1.05.
SC990 occurs under these conditions:
-
The main power is turned ON while the paper tray is
open
-
Then, the color sample sheet is printed out
B
ulletin
Date:
24-Feb-05
Symptom Corrected
PAGE: 2/3
No.:
RG104003h
Advertisement
