Advertisement
Reissued: 15-Apr-05
Model:
General RTB
6. ERROR RECOVERY
There are three ways to recover from a loss of power during RFU.
6.1 Recovery Procedure
There are three types for recovery after a power loss during RFU. (This will depend on
the firmware and model). Procedures for types 1, 2 and 3 are on the next page.
Find the firmware and model you are downloading to, and begin with the type shown
in the table below.
Recommendation:
As mentioned in 5. Updating Procedure, it is strongly recommended that RFU be
performed on-site, to minimize the chances of a power-down during RFU.
Printers
Model
System Network WebSys Printer
Model J-P2
Type1
Model J-P2CF Type1
Model K-P3
Model C-P1
Model J-P3
Type1
Model PL-P1
Type1
Model G-P1
Type1
Model C-P2
Type1
Model K-P4
Type1
MFPs
Model
System Network WebSys Printer
Model A-C3e/f
Type2
Model R-C3
Type2
Model K-C2
Type1
Model S-C2
Type1
Model B-C2e
Type2
Model J-C1
Type1
Model MT-C2
Type2
T
echnical
Type1
---
Type1
---
Type1
Type1
Type1
Type1
Type3
Type3
Type1
Type1
Type1
Type1
Type1
Type1
Type1
Type1
Type2
Type2
Type2
Type2
Type1
Type1
Type1
Type1
Type2
Type2
Type1
Type1
Type2
Type1
Fig. 3 Recovery Method
B
ulletin
Date:
15-Nov-04
Engine Card Type
Type1
Type1
IC
Type1
Type1
IC
Type1
Type1
IC
Type1
Type1
IC
Type3
Type1
SD
Type1
N/A
SD
Type1
Type1
SD
Type1
Type1
SD
Type1
Type1
SD
PS
Engine Card Type
Type2
Type2
Type1
Type2
Type2
Type1
Type3
Type3
Type3
Type3
Type3
Type1
Type3
Type3
Type3
Type3
Type3
Type1
Type1
Type1
Type1
PAGE: 12/15
No.:
RGene019a
IC
IC
SD
SD
SD
SD
SD
Advertisement
