Advertisement
Reissued: 15-Apr-05
Model:
General RTB
5.6 Checking the Result of the Update
Check that the firmware has been updated.
Note:
•
After transmitting the firmware file from the computer, it takes approximately 3 to 5
minutes for updating to complete and the machine to restart.
•
To check the result, you need to logon to the machine again using ftp. However,
you cannot log on during the update process, so you are unable to check that the
update has completed until the machine has restarted.
If the update was successful
•
Once the firmware has been updated successfully, the system automatically
restarts using the new firmware.
After the restart, verify that the firmware has been updated to the new version.
Check that the error code in the error data file (errlog.txt) is "0" by performing
procedure 7.1 "Checking the error status" (below).
If an error occurs
•
If an error occurs during the update, the system automatically restarts, the
message shown below appears, and the machine waits to receive the firmware
file again. If the update is interrupted by a power failure, the same thing happens
once the power is restored.
Log on to the machine again using ftp and then resend the firmware file to the
machine.
The following message appears for Type 1 firmware:
Display panel (MFPs)
o
Display (Printers)
o
ROM Update
Waiting for Data_
T
B
echnical
xxx.xxx.xxx.xxx
⇔
ulletin
Date:
15-Nov-04
PAGE: 11/15
No.:
RGene019a
Advertisement
