Advertisement
Reissued: 21-Apr-06
Model:
Model G-P1
Version
1.06.1
Stall
1.07.2
Some features of a
customization added
1.08.1
PCL
1.09
RPJL
1.10
Meter charge mode
T
echnical
Title
If a duplex job is sent using the RPCS driver and
cancelled from the operation panel or PC, the device
may stall.
Some features of a customization were added as
standard:
-
The IP address is displayed on the LCD.
-
The IP address can be displayed on the LCD when
an error message occurs (Hold down the "Menu" key
for more than 5 seconds).
NOTE: To use these two features, you must set Sp5-055-
001 (Display IP Address) to "ON." You can do this from
the operation panel or from WIM.
Can not print Thai/Latin characters using the PS
-
driver.
Important:
Websys firmware v1.07 (P/N G1045235C) or later
must be used with all of the firmware together.
NIB firmware v4.14.1 or later (P/N G1045234C)
Controller v1.07.2 or later (P/N G1045239F)
Printer v1.07.2 or later (P/N G1045243F)
When PCL data is printed using HDD fonts, print
speed might be reduced.
After a certain number of PCL jobs are printed using
HDD fonts, the device may stall
(GFPR#RE05060001).
Fixed: Data containing multiple jobs that have the
PJL parameters START and END, might be
cancelled (GFPR#RA05070002).
Other changes (specification change):
PM alert messages will be displayed even in Meter
Click Mode (refer to RTB RG104012).
Important: To use the above new feature, you need
to install all of the following firmware together as a
set.
System v1.10 or later (P/N #G1045243J)
Printer v1.10 or later (P/N #G1045239J)
Engine v1.12:01 or later (P/N #G1045130H)
B
ulletin
Date:
24-Feb-05
Symptom Corrected
PAGE: 2/3
No.:
RG104003g
Advertisement
