Advertisement
Model:
Model G-P1
Subject:
Required actions after cleared NVRAM data
From:
1st Tech. Support Sec. Service Support Dept.
Classification:
Important Note Regarding the NVRAM Clear
Do the following procedure if you do not have the old SMC data from before an NV-RAM
clear.
1. Re-program the SP modes in the tables below with the values on the SMC Factory
Settings Sheet.
Note:
! From June 2005 production, the SMC Factory Settings Sheet is attached to the
inside of the lower rear cover.
! For before June 2005 production, the factory settings data is stored at the factory.
[Destin./Model] Destination
Code/Model
[Phase Adjust.] Phase
Adjustment
[Area Shading] Area Shading
Correction Setting
[P sensor Prm.] ID Sensor
Parameter
[Lead Edge Reg.] Leading
Edge Registration
[S-to-S Reg.] Side-to-Side
Registration
T
echnical
Troubleshooting
Mechanical
Paper path
Other (
)
5-807-001
5-807-002
1-006-001
2-152-006
2-152-007
2-152-008
2-152-009
2-152-010
2-152-011
2-152-012
2-152-013
2-152-014
2-152-015
3-148-001
1-001-002
1-001-014
1-001-018
1-002-001
1-002-002
1-002-005
B
ulletin
Date:
20-Jul-05
Prepared by:
Part information
Electrical
Transmit/receive
2-152-016
2-152-026
2-152-017
2-152-027
2-152-018
2-152-028
2-152-019
2-152-029
2-152-020
2-152-030
2-152-021
2-152-031
2-152-022
2-152-032
2-152-023
2-152-033
2-152-024
2-152-034
2-152-025
2-152-035
PAGE: 1/2
No.:
RG104008
K. Moriizumi
Action required
Service manual revision
Retrofit information
2-152-036
2-152-046
2-152-037
2-152-047
2-152-038
2-152-048
2-152-039
2-152-049
2-152-040
2-152-041
2-152-042
2-152-043
2-152-044
2-152-045
Advertisement
