Advertisement
Reissued:5-Sep-05
Model:
Model G-P1
RTB Reissue
The items in bold italics have been added.
Subject:
Controller firmware (NIB) release note for G-P1
From:
1st Tech. Support Sec. Service Support Dept.
Classification:
This RTB has been issued to announce the printer firmware (NIB) release information for
the Model G-P1 controller board.
NIB
Version
4.00
4.08.3
4.14.1
4.15.1
NIB
Version
4.00
1st mass production
4.08.3
Minor changes applied to improve reliability.
4.14.1
If the paper type setting is changed via WIM while "Permit Settings by SNMPv1
and v2" is disabled, the browser will timeout. The paper type setting change will
not be saved.
SNMPv1/v2 will still send SNMP traps even if the SNMPv1/v2 function is
disabled.
Sometimes after a power cycle, the device will be unable to accept jobs from
standard TCP/IP or SDM ports.
If a lot of SNMP traffic is sent to the device, the SNMP buffer may become full.
The result of this is that the device will not be able to reply to SNMP requests.
SDM for Admin, running on a client PC that is connected to both a 1394 and
ethernet interface, will not be able to retrieve the 1394 hostnames of devices.
The SNMP service may not start when the device is turned on. Utilities using
SNMP will not receive status updates from the device.
The device can accept multiple incoming diprint (port9100) sessions.
Communications via diprint (port9100) are now transmitted asynchronously.
Leading zeros will be removed from byte-counts in LPD control files (zero-
4.15.1
suppression).
The firmware cannot be updated via RC Gate if the administrator password
is blank.
T
echnical
Troubleshooting
Mechanical
Paper path
Other (
)
Program No.
G1045234A
G1045234B
G1045234C
G1045234D
B
ulletin
Date:
Prepared by:
Part information
Electrical
Transmit/receive
Effective Date
1st mass production
March 2005 production
July 2005 production
August 2005 production
Symptom Corrected
No.:
29-Jun-05
K. Moriizumi
Action required
Service manual revision
Retrofit information
PAGE: 1/1
RG104007a
Advertisement
