Configuring For An External Meter - Measurement Computing Data Translation DT3010 Series User Manual

Chapter 8
To calibrate DAC1 using the internal ADC, do the following:
1. Connect Analog Out 1+ to Analog In 3.
2. Connect Analog Out Return to Analog In 3 Return.
Analog Output 1+ Return
Analog Input 3 Return
For the DT3010, DT3010-268, DT3010/32, DT3010/32-268 board, follow the instructions on
page

Configuring for an External Meter

To calibrate DAC0 using an external voltage meter, do the following:
1. Connect Analog Out 0+ to the positive side of the precision voltage meter.
Analog Output 0+
2. Connect Analog Out 0 Return to the negative side of the precision voltage meter.
Analog Output 0 Return
170
DT740 Screw
Signal
Analog Output 1+ TB43
Analog Input 3 TB7
Signal
TB44
TB8
171. For the DT3016 board, follow the instructions on
Signal
TB41
Signal
TB42
STP268 Screw
Terminal Terminal on J1
TB43
TB7
DT740 Screw STP268 Screw
Terminal Terminal on J1
TB42
TB8
DT740 Screw STP268 Screw
Terminal Terminal on J1
TB41
DT740 Screw STP268 Screw
Terminal Terminal on J1
TB42
STP268-EC
Screw Terminal
TB16
TB31
STP268-EC
Screw Terminal
TB51
TB65
page 173.
STP268-EC
Screw Terminal
TB17
STP268-EC
Screw Terminal
TB51