Measurement Computing Data Translation DT3010 Series User Manual page 161

Chapter 8
The DT3010 Series boards are calibrated at the factory and should not require calibration for
initial use. We recommend that you check and, if necessary, readjust the calibration of the
analog input and analog output circuitry on the DT3010 Series boards every six months.
The DT3010 Calibration Utility is provided for calibrating the DT3010, DT3010-268,
DT3010/32, and DT3010/32-268 boards. The DT3016 Calibration Utility is provided for
calibrating the DT3016 board.
Note: Ensure that you installed the DT3010 Series Device Driver prior to using the DT3010
or DT3016 Calibration Utility. Refer to
loading the device driver.
This chapter describes how to calibrate the analog input and output subsystems of DT3010
Series boards using the DT3010 and DT3016 calibration utilities.
160
Chapter 2 starting on page 25 for more information on