Understanding the printer menus
Use
Lock PS Startup Mode
On
Off
Font Priority
Resident
Flash/Disk
Image Smoothing
On
Off
PCL Emul menu
Use
Font Source
Resident
Disk
Download
Flash
All
Font Name
Courier 10
To
Enable users to disable the SysStart file.
Note: Off is the factory default setting.
Establish the font search order.
Notes:
•
Resident is the factory default setting.
•
This menu item appears only when a formatted, non‑defective flash
memory option card or printer hard disk is installed.
•
Make sure the flash memory option or printer hard disk is not
read/write‑, write‑, or password‑protected.
•
Job Buffer Size must not be set to 100%.
Enhance the contrast and sharpness of low‑resolution images and
smoothen their color transitions.
Notes:
•
Off is the factory default setting.
•
Image Smoothing has no effect on images that are 300 dpi or higher
in resolution.
To
Specify the set of fonts used by the Font Name menu.
Notes:
•
"Resident" is the factory default setting. Resident shows the factory
default set of fonts downloaded in the RAM.
•
"Flash" and "Disk" settings show all fonts resident in that option.
•
The flash option must be properly formatted and cannot be
read/write‑, write‑, or password‑protected.
•
"Download" shows all the fonts downloaded in the RAM.
•
"All" shows all fonts available to any option.
Identify a specific font and the option where it is stored.
Note: Courier 10 is the factory default setting. Courier 10 shows the font
name, font ID, and the storage location in the printer. The font source
abbreviation is R for Resident, F for Flash, K for Disk, and D for
Download.
194