Craft Port; Table 6. Ntwk Connection Pinout; Table 7. Craft Pinout; Table 8. Db-9 To Rj-48 Adapter Pinout - ADTRAN 604 System Manual

Total Access 600 Series System Manual
PIN
1
2
3, 6-8
4
5

CRAFT Port

The port (EIA-232) on the rear panel connects to a computer or modem and provides the following
CRAFT
functions:
• Accepts EIA-232 input from a PC or a modem for controlling the Total Access 600 Series.
• Baud rate is user-configurable.
• Acts as input for either VT100 or PC control.
• Acts as an interface for flash memory software downloads using XMODEM.
Table 7 shows the
CRAFT
PIN NAME
1 GND
2 RTS
3 RXDATA
4 DTR
5 TXDATA
6 CD
7 —–––––
8 CTS
A DB-9 to RJ-48 adapter is needed to connect a PC or VT100 terminal to the
not part of the Total Access 600 Series shipment. You may obtain a free adapter (P/N 3196ADPT001) by
contacting ADTRAN Technical Support or by adding the adapter to the system order. You can also build
your own adapter by purchasing unassembled adapter kits from Black Box or Datacomm Warehouse (or
other equivalent companies). The adapter pinout is shown in Table 8.
DB-9 RJ-48
2 5
3 3
5 1
61200624L1-1B

Table 6. NTWK Connection Pinout

NAME
RX RING Receive data from the network
RX TIP Receive data from the network
—––––– Unused
TX RING Transmit data toward the network
TX TIP Transmit data toward the network
port pinout.

Table 7. CRAFT Pinout

Ground – connected to unit chassis
Request to send – flow control
Receive data
Data terminal ready
Transmit data
Carrier detect
Unused
Clear to send - flow control

Table 8. DB-9 to RJ-48 Adapter Pinout

Transmit Data
Receive Data
Ground
© 2004 ADTRAN, Inc.
Section 2 Engineering Guidelines
DESCRIPTION
DESCRIPTION
CRAFT
DESCRIPTION
port. This adapter is
31