Appendices (T1 Tdm Applications); Initial Setup; Setting Up The Interfaces - ADTRAN 604 System Manual

Section 4 User Interface Guide
4.

APPENDICES (T1 TDM APPLICATIONS)

Initial Setup

It is best to configure Total Access 6XX TDM applications by following the order of the top-level menus.
For example, first configure the system parameters using the
Next, configure the Layer 1 parameters using the
configured, proceed to the Layer 2 setup using the
data "routing" menus (either
menus. Lastly, configure the physical mappings using the
S
ECURITY
The following example provides step by step instructions for configuring the Total Access 6XX T1 TDM
system ( through
I
NTERFACES
Config parameters should be set according to your system need. Refer to System Info on page 49 and
System Config on page 51 for more details.

1. Setting up the Interfaces

For more details on the configuration parameters discussed in this section, refer to the following pages:
Network T1 menus beginning on
Ethernet menus beginning on
Step
1 From the main menu, select I
Highlight the C
2
Right arrow to select F
3
This format must match the format used by the other units in the network.
4 Set the L
This line code must match the line code used by the other units in the network.
Set the E
5
sufficient.
Set the CSU L
6
whether looping to this unit from another unit will be allowed.
152
Appendix A. Configuring the Unit for Routing
or
B R
RIDGE OUTER
) for a standard routing application. System Info and System
DS0 M
APS
page 71
page 81
T1 Interface Setup Instructions
menu for the T1 interface and press <E
ONFIG
ORMAT
C to B8ZS or AMI.
INE ODE
or line build out. The default setting of 0
QUALIZATION
option to E
PBK
© 2004 ADTRAN, Inc.
Total Access 600 Series System Manual
S I
YSTEM NFO
menu. Once the Layer 1 information is
I
NTERFACES
menus. Follow the Layer 2 setup with the
L2 P
ROTOCOL
). Establish packet forwarding and blocking using the
DS0 M
Action
.
NTERFACES
and choose ESF or SF.
, D , or D
NABLE ISABLE ISABLE
and menus.
S C
YSTEM ONFIG
menus.
APS
>.
NTER
B is usually
D
A based on
LL
61200624L1-1B