ADTRAN 604 System Manual page 180

Section 4 User Interface Guide
Router Options – T1 Interface (L2 Protocol = ATM) (Continued)
Select I
S
ETUP
3
T1 interface defined in the PVC C
I
NTERFACES
4 Set A
5 Enter the appropriate VPI and VCI values.
Select the desired A
6
more details.
Enter the Total Access 6XX L
7
N
ETMASK
8 Enter the IP address for the next hop router in the F
For NAT configuration, refer to Appendix C. RFC1483 Quick Start (IP Routing
9
with NAT) on page 179.
10 Left arrow back to the main menu to save the changes.
Step
1 From the main menu, select R
2 Use the right arrow key to highlight C
Select R
3
appropriate IP address.
4 Left arrow back to the main menu to save the changes.
178
and press <E
NTERFACES
field for the T1 interface and press <E
table.
to Y to activate the virtual circuit.
CTIVE ES
M
DDRESS
for the selected virtual circuit.
Router Options – Setting the Default Gateway
and press <E
OUTES
© 2004 ADTRAN, Inc.
Total Access 600 Series System Manual
>. Use the right arrow key to highlight the
NTER
>. Each virtual circuit on the
NTER
has a separate listing in the R
ONFIG
. Refer to Address Mode on page 122 for
ODE
IP A and corresponding IP
OCAL DDRESS
AR
Action
and press <E
OUTER NTER
and press <E
ONFIG
>. Set the D
NTER EFAULT
OUTER
-E IP A field.
ND DDRESS
>.
>.
NTER
G field to the
ATEWAY
61200624L1-1B