Interfaces (Fxo) - ADTRAN 604 System Manual

Section 4 User Interface Guide
I (FXS) > S
NTERFACES
This parameter displays the status of the Receive A signal bit. The high/low status is indicated by a 0 or 1.
I (FXS) > S
NTERFACES
This parameter displays the status of the Receive B signal bit. The high/low status is indicated by a 0 or 1.
I (FXS) > T
NTERFACES
Activate tests and monitor test status on a per port basis from this menu.
I (FXS) > T
NTERFACES
Displays the port number.
I (FXS) > T
NTERFACES
Choices are given below. Default is
N
ONE
D N
IGITAL ETWORK
L
PBK
N O H
ETWORK N
T
EST
N O
ETWORK FF
T
EST
C R
USTOMER ING
I (FXS) > T
NTERFACES
This option indicates whether a test is in progress.
I (FXO)
NTERFACES
View the FXO interface status and configure the FXO parameters from this menu.
FXO interfaces are only available with Total Access 624 systems.
86
> RA S
TATUS IG
> RB S
TATUS IG
EST
> P
EST ORT
> T
EST EST
.
N
ONE
Indicates that no test is currently active.
Used to loop back DS0 data coming from the network for each channel.
Received data is latched in on the appropriate receive time slot on the
receive bus. This data is then placed on the transmit bus in the unit's
transmit time slot.
Used to test signaling sent to the network by the unit. On-hook signaling
OOK
is sent to the network. The customer loop is forced on-hook while this
test is active.
H Used to test signaling sent to the network by the unit. Off-hook signaling
OOK
is sent to the network. The customer loop is forced off-hook while this
test is active.
T The customer ring test will activate the unit's ring relay in a
EST
2-on /4-off cadence, providing ringing to the customer loop.
> T S
EST EST TATUS
© 2004 ADTRAN, Inc.
Total Access 600 Series System Manual
61200624L1-1B