ADTRAN 604 System Manual page 167

Total Access 600 Series System Manual
Press <E
11
port mode is set to T
12 Set the C
13 Set the S
Be sure to set the T
2. Mapping the DS0s
For more details on the configuration parameters discussed in this section, refer to the following pages:
DS0 Map menus beginning on
Step
1 From the main menu, select DS0 M
Verify that the A
is actively running on the unit. The unit has the ability to store two maps.
• To edit the current map, press <E
2
map. (If Map 1 is the Active Map)
• To edit the standby map, press <E
map. (If Map 2 is the Active Map)
The
on the network T1 interface.
3 Scroll down to the DS0 that will be mapped.
4 Set the S
Set the P
5 match the voice port the DS0 is being mapped to. RBS (robbed bit signaling)
will automatically turn on when a port number has been selected.
Map all the DS0s as desired, and exit this menu by pressing the left arrow
6
button. Your changes will automatically save when exiting the map.
Make sure the A
7
running) before exiting the DS0 M
8 Left arrow back to the main menu.
61200624L1-1B
FXS Interface Setup Instructions (Continued)
> on the T
NTER ANDEM
ANDEM
M of the port to either L
ONVERSION ODE
of the port to either I
UPERVISION
options for each port set to T
ANDEM
page 149
DS0 Mapping Instructions
M is set to either M
CTIVE AP
listed on the left side of the menu corresponds to DS0s (1 through 24)
DS0
for the DS0 that you are mapping to FXS.
ERVICE
of the DS0 that you are mapping. The port number entered must
ORT
M
CTIVE AP
© 2004 ADTRAN, Inc.
[+] option to view the T
(E&M).
OOP
MMEDIATE
Action
.
APS
1 or M
AP
> on E
NTER DIT
> on E
NTER DIT
is set to the correct map (the map you want
menu.
APS
Section 4 User Interface Guide
options if the
ANDEM
S or G S
TART ROUND TART
or W .
INK
E&M.
ANDEM
2. This is the map that
AP
/V M 1 to view the
IEW AP
/V M 2 to view the
IEW AP
.
165