ADTRAN 604 System Manual page 177

Total Access 600 Series System Manual
Step
1 From the main menu, select I
Highlight the C
2
Right arrow to select F
3
This format must match the format used by the other units in the network.
4 Set the L
This line code must match the line code used by the other units in the network.
Set the E
5
sufficient.
Set the CSU L
6
whether looping to this unit from another unit will be allowed.
Most applications should not require a manual setup for the Ethernet interface. By
default, the Ethernet interface is configured to auto-detect the data rate (as either 10
or 100 Mbps). The following steps disable the auto-negotiation parameter and
manually configure the interface.
Step
1 From the main menu, select I
Highlight the C
2
Use the right arrow to select A
3
down arrow to choose OFF.
4 Select the D
5 Select the D
61200624L1-1B
T1 Interface Setup Instructions
NTERFACES
menu for the T1 interface and press <E
ONFIG
and choose ESF or SF.
ORMAT
C to B8ZS or AMI.
INE ODE
or line build out. The default setting of 0
QUALIZATION
option to E
PBK NABLE
Ethernet Interface Setup Instructions
NTERFACES
menu for the ETH interface and press <E
ONFIG
UTONEGOTIATION
R field and specify either 10B
ATA ATE
T field and specify either H
UPLEX YPE
© 2004 ADTRAN, Inc.
Section 4 User Interface Guide
Action
.
, D , or D A
ISABLE ISABLE
Action
.
and press <E
T or 100B
ASE
D
ALF UPLEX
>.
NTER
B is usually
D
based on
LL
>.
NTER
>. Use the
NTER
T.
ASE
or F D .
ULL UPLEX
175