Interfaces (Eth) - ADTRAN 604 System Manual

Total Access 600 Series System Manual
I (DSX) > T
NTERFACES
Sends a loopback command across the network to a remote unit over the FDL, which causes the remote
unit initiate a local
L
INE
available when the T1 is configured for ESF mode.
I (DSX) > T
NTERFACES
Indicates whether a test is in progress.
I (ETH)
NTERFACES
View the Ethernet interface status and configure the Ethernet parameters from this menu.
I (ETH) > C
NTERFACES
Configure the various Ethernet parameters from this menu.
I (ETH) > C
NTERFACES
The Total Access 600 Series has the capability of auto negotiating the rate and duplex of the connected
Ethernet link. Additionally, when this parameter is set to
I (ETH) > C
NTERFACES
Defines the Ethernet interface as
is set to
A N
UTO EGOTIATION
I (ETH) > C
NTERFACES
Defines operation on the Ethernet interface as
is only available when
A
I (ETH) > S
NTERFACES
Displays the Ethernet status information.
I (ETH) > S
NTERFACES
(Read only) Displays the unique MAC address programmed at ADTRAN.
I (ETH) > S
NTERFACES
Displays the current status of the Ethernet link as either
status displays .
U
P
61200624L1-1B
> R LB
EST EM
or loopback (whichever is specified). The remote loopback is only
P
AYLOAD
> T S
EST EST TATUS
ONFIG
> A N
ONFIG UTO EGOTIATION
> D R
ONFIG ATE ATE
or
100B T 10B
ASE
.
O
FF
> D T
ONFIG UPLEX
F
is set to
N
UTO EGOTIATION
TATUS
> MAC A
TATUS DDRESS
> D L
TATUS ATA INK
© 2004 ADTRAN, Inc.
, the rate and duplex are set manually.
O
FF
. configuration is only available when
T D R
ASE ATA ATE
YPE
or
D H D
ULL UPLEX ALF UPLEX
.
O
FF
or . If there is an active Ethernet link, the
U D
P OWN
Section 4 User Interface Guide
. configuration
D T
UPLEX YPE
81