12 Electrical connection
12
Electrical connection
Note! During any work with the electrical connections the mains must be disconnected.
• Place the electric switch easily accessible from the operator. If an plug contact is used in the
installation the wall socket shall be placed easily accessible from the operator.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
See Auto-learn-automatically sets back and latch check (recommended) on page 76.
If R/S < 192mm, the connection box should be rebuilt.
Mains connection
a Switch off the mains.
b Connect the plug contact to the wall socket or connect to the mains switch.
Alt. 1 (Standard)
Remove the protective lid (1) and connect the incoming mains through the strain relief (2) to the
connection block (3).
62
Issue 2021-02-04
1
Protective lid
2
Strain relief
3
Connection block
1007913-en-20.0