Electrical Connection - Assa Abloy besam SW100 Installation And Service Manual

11
11.1 Connection box
1003680-US-4.0
• During any work with the electrical connections the mains power must be discon-
nected.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
Fitting
Fit the connection box in the back plate as shown below.
Note: To ensure for sufficient grounding, the square nuts must be turned with the teeth
upwards against the box so that they cut through the anodizing in the back plate.
Connection
1. Switch off the mains power.
2. Unscrew the lid.
3. Connect the mains cable to the internal cable inside the connection box as shown
below. Be aware, local code shall be followed.
4. Re-install the lid.
5. Connect the mains contact to the operator.
Mains
contact
Issue 2007-10-11

Electrical connection

Mains power
120 V AC – 60 Hz
N
Ground L
(White)
(Green) (Black)
Electrical connection
Mains switch
(by others)
0
0
Lid
31