Table of Contents
Advertisement
Safety accessories
Combined motion and presence sensors
Separate presence sensors (presence in the door opening or side presence for the trailing edge
of the door)
General accessories
Cover
Made in clear anodized aluminium .
Electrical locks
The following locks are available to the operator:
Locked with power (LDP), fail safe
Electrical opening with the battery unit
Used if a door is required to be opened by means of a rechargeable battery unit and remain in this
position in the event of power failure. The battery can be monitored.
Troubleshooting
What´s wrong?
The door does not open
The motor does not start
The motor starts but stops during
opening
The door does not close
The motor does not start
The motor starts but stops during
opening
The door moves slowly
If the problem continues, please contact your ASSA ABLOY Entrance Systems representative.
18
Change the setting of the mode selector.
Check the mains power and fuse in the building.
Unlock the mechanical locks.
Clean the floor guide.
Check for objects jammed under the door.
Change the setting of the mode selector.
If a presence sensor is installed, check for and remove objects placed in the
presence zone.
Clean the floor guide.
Check for objects jammed under the door.
Prevent traffic from using the door and allow it to close completely.
Reset the operator by briefly pushing the reset button (see page 10).
Issue 2022-03-16
Remedies
1020882-en-5.0
Advertisement
Table of Contents
