Classification (Level 3) - Assa Abloy SW300 Installation And Service Manual

16.4

Classification (Level 3)

a Disconnect batteries if any.
b Disconnect the mains.
c Press the LEARN BUTTON (LRN) and keep it depressed.
d Connect the mains.
e Watch the ERROR LED.
f Release the LEARN BUTTON after 3 flashes (LED is out).
g Identify the current classification
The ERROR LED flashes an amount of short flashes that correspond to the classification number.
After a short pause the LED will repeat the classification number and so on.
h Changing the classification
If you push the LEARN BUTTON once, the classification number will increase. When you have
reached the highest classification number it will start at number one again.
• Push the button until you get the requested classification
• Disconnect the mains
Next time the mains is connected, the operator will use the new classification.
i Classification table
See the "Guide for installers of Powered Pedestrian Swing Doors", Product Risk Assessment
document PRA-0006, for calculation of speed.
Classification
Standard
Opening speed
Closing speed
The fastest setting of Opening Speed and Closing Speed are automatically limited to the value
in the table, and can only be reduced.
If classification 2, Low energy, is used the operator will automatically follow the speed limitation
in EN 16005.
The learn procedure must be carried out after a change of the classification setting.
Speed settings for Low energy mode
The table shows minimum opening time to back check or to 80° open or minimum closing
time from 90° to 10° open.
1007913-en-20.0
1
Full power(Default)
2.5 - 12 s
4 - 12 s
Width of door leaf (mm)
750
850
1000
1200
Issue 2021-02-04
2
Low energy
EN 16005
Automatic limitation 1.69 J
Automatic limitation 1.69 J
Door mass (kg)
50 60 70
Time (s) min
3,0 3,2 3,2
3,1 3,1 3,2
3,2 3,4 3,7
3,8 4,2 4,5
16 Advanced settings
80 90
3,3 3,5
3,4 3,6
4,0 4,2
4,8 5,1
85