14
Cover
The cover and back plate are manufactured in clear anodized aluminium. The end plates are made
of black painted steel sheet.
14.1
Fitting and removing the cover
The cover is slid over flanges in the back plate so that the ridges fit in the grooves. Snap on the fill
cover into the slot for output shaft. Secure cover with the screw.
When properly installed and adjusted, attach the product label, which includes the CE mark on the
right side of the lower part of the operator cover (see illustration).
Apply the ASSA ABLOY logotype to the cover see illustration.
Only for SE: Apply the SITAC label next to the product label - see illustration.
14.2
Cover piece kit
Single door
Double door
1007913-en-20.0
X
CL-843.5
CL-1682
Issue 2021-02-04
14 Cover
79